Release the roll feed button and all should be well. Left) and keep it down until the machine finishes whirring, cleaning etcġ0. Press and hold down the ROLL FEED button (the one at the extreme When red and green lights are both on, release the roll and sheetĩ. Switch printer off and then, after a few seconds, on again at mainsĨ. Pressing and holding PAUSE, LF/FF and DOWN ARROW buttons. In 2-3 seconds time press and hold CLEANING button for 10-12 seconds. press POWER button, You will see blinking INK OUT led. Continue to hold down roll and sheet feed buttons until both greenĪnd red lights come on together, not alternatelyħ. Pressing and holding LOAD/EJECT and CLEANING buttons. Hold down roll feed and sheet feed buttonsĦ. Switch off printer at mains switch - leave off for 20+ secondsģ. If you decide to reset the counter, this is how to do it:Ģ. This efficient 17.7 by 22.5 by 11.3 inch photo printer produces a maximum resolution of 5760 by 1440 dpi for crystal-clear photographs printed with smudge, scratch, fade, and water resistant Claria Hi. I reset mine two years ago and have had no problems, but I'm a light printer. Print text documents at 38 pages per minute and print standard 4 by 6 inch photos in 11 seconds with the Epson Stylus Photo R280 photo printer. There's probably little risk of ink overflowing, but it depends on how much printing you do. The amount of ink is not physically measured: there is an electronic counter that has reached the "full" state, and while you should in theory take your printer to a service centre for servicing, it is possible to reset the counter and carry on printing. These are sponges at the bottom of the printer that mop up surplus ink when heads are cleaned etc. I believe that the flashing lights indicate that the ink waste pads need servicing.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |